ChainTools consists of two commands: ChainTrim and ChainSplit. In ChainTrim you interactively build a set (chain) of trimming curves on an object to be finally trimmed. When picking the curves, you have control of how the trimming chain will look like, which intersections, edges or curves it will include. The command checks and warns if there is no continuity between the curves or to an edge of the trimmed object. It also allow you to extend the curves on the trimmed surface. ChainSplit works similarly, the only difference is that all parts of the splitted object remain.
To use ChainTools commands, simply type "ChainTrim" or "ChainSplit" in the command line. You can also use buttons in a dedicated toolbar that will appear in Rhino when the plug-in is installed.
The plug-in available in food4rhino is in demo mode, it is limited to 7 uses per Rhino session,
and also it changes layers of the affected objects.
To buy full version or see more details, visit my website:
See also videos available below.
Some of release notes:
version 0.7.0.0, date 24-01-2021
- first issue
version 0.9.9.0 date 27-11-2021
- Doccurves detection improved, matched/demo plug-in version introduced
version 0.9.9.1 date 29-11-2021
- Minor update
version 188.8.131.52 date 2-01-2022
- Minor update, versions matched and demo
version 184.108.40.206 date 13-01-2022
- Update in doccurves detection, matched/demo version
version 220.127.116.11 date 19-01-2022
- Update in comp ID generation