AxonOblique
(by menno)
This is the first release of my plug-in to show and create geometry in axonometric and oblique views.

This utility for these views exposes four c
Support Email

This is the first release of my plug-in to show and create geometry in axonometric and oblique views.

This utility for these views exposes four commands:

  • Axonometric - switch on or off axonometric view in the "Top" viewport.
  • Obliqe - switch on or off oblique view in the "Top" viewport.
  • MakeAxonometric - select geometry to transform by axonometric transform.
  • MakeOblique - select geometry to transform by oblique transform.

These commands make it possible to show the axonometric or oblique transformation in a viewport that is called "Top". If you use a different language, rename a viewport to see the projection.

I have tested this project, but it is the first release and it might contain still bugs. Please use it "as is", it does not come with warranties. I spent a lot of time developing the logic and implementing it, please give credit where credit is due.

To install, download the RHP plug-in file and save it to a location of your choice. Then, drag the file onto Rhino to install the plug-in. Dragging is needed only once.

You need to run Rhino 5.0 SR7 or higher for this plug-in.

If this plug-in is useful to you, please condider a donation to support further development Donate using Paypal

 

- Menno Deij - van Rijswijk
License:
Reviews